Siemens RUGGEDCOM ROX II User Manual

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
440 Adding an Event Tracker
This list provides the following information:
Parameter Description
echo-attempts Synopsis:  A 32-bit unsigned integer
The number of echo attempts.
echo-replies Synopsis:  A 32-bit unsigned integer
The number of echo replies.
min-rtt Synopsis:  A string
The minimum of the round trip time (in milliseconds).
average-rtt Synopsis:  A string
The average of the round trip time (in milliseconds).
max-rtt Synopsis:  A string
The maximum of the round trip time (in milliseconds).
standard-deviation-rtt Synopsis:  A string
The standard deviation of the round trip time (in milliseconds).
Section13.5.3
Adding an Event Tracker
To add an event tracker, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the event tracker by typing:
global tracking event name
• name is the name of the tracking event
3. Configure the following parameter(s) as required:
Parameter Description
target { target } Synopsis:  A string 1 to 253 characters long
Configures the ping target as an IPv4 address or hostname.domain.
This parameter is mandatory.
source-ip { source-ip } Synopsis:  A string 7 to 15 characters long or a string 6 to 40 characters long
Sets the source address to a specified IPv4 address.
source-interface { source-interface } Synopsis:  A string
Forces a ping on a selected interface.
timeout { timeout } Synopsis:  A 32-bit unsigned integer
Determines how many milliseconds to wait for the ICMP response.
This parameter is mandatory.
interval { interval } Synopsis:  A 32-bit unsigned integer equaling 100 or higher
Determines how many milliseconds to wait before sending another ICMP request.
This parameter is mandatory.
fall { fall } Synopsis:  A 32-bit unsigned integer equaling 1 or higher

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English