Siemens RUGGEDCOM ROX II User Manual

Chapter 4
Device Management
RUGGEDCOM ROX II
CLI User Guide
76 Enabling/Disabling the XPATH Trace Log
.
.
**> sess:9450 read:
<rpc xmlns="urn:ietf:params:xml:ns:netconf:base:1.0" message-id="103">
<validate>
<source>
<running/>
</source>
</validate>
</rpc>
**< sess:9450 write:
<rpc-reply message-id="103" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<ok/>
</rpc-reply>
.
.
.
CAUTION!
Configuration hazard – risk of reduced performance. Enabling diagnostic logging will significantly
affect the performance of RUGGEDCOM ROX II. Only enable diagnostic logging when directed by
Siemens.
To enable or disable the NETCONF Trace log, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable the NETCONF Trace log by typing the following commands:
Enable
admin logging diagnostics netconf-trace-log enabled
Disable
no admin logging diagnostics netconf-trace-log enabled
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section4.10.4.5
Enabling/Disabling the XPATH Trace Log
The XPATH trace log records internal events related to XPATH routines that require interaction with an XPATH
component.
CAUTION!
Configuration hazard – risk of reduced performance. Enabling diagnostic logging will significantly
affect the performance of RUGGEDCOM ROX II. Only enable diagnostic logging when directed by
Siemens.
To enable or disable the XPATH Trace log, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable the XPATH Trace log by typing the following commands:
Enable
admin logging diagnostics xpath-trace-log enabled

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English