Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 7
IP Address Assignment
Deleting a Subnet 239
8. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.8.4
Deleting a Subnet
To delete a subnet, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the subnet by typing:
• For IPv4
no services dhcpserver subnet-name name
• For IPv6
no services dhcpserver6 subnet6-name name
Where:
• name is the name of the subnet
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.9
Managing Host Groups
Host-groups allow identical settings to be created for a group of hosts, making it easier to manage changes to the
settings for all the hosts contained within the group. Host-groups contain hosts.
CONTENTS
• Section7.3.9.1, “Viewing a List of Host Groups”
• Section7.3.9.2, “Adding a Host Group”
• Section7.3.9.3, “Configuring Host Group Options”
• Section7.3.9.4, “Deleting a Host Group”
Section7.3.9.1
Viewing a List of Host Groups
To view a list of host groups, type:
• For IPv4
show running-config services dhcpserver host-groups
• For IPv6
show running-config services dhcpserver6 host-groups
If host groups have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services dhcpserver host-groups
services
dhcpserver
host-groups "Local Group"

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English