Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 4
Device Management
Viewing SFP Information 97
Smart SFP enables RUGGEDCOM ROX II to automatically configure the speed and auto-negotiation settings for the
socket to match the transceiver. Settings are based on the capabilities read from the SFP transceivers EEPROM.
IMPORTANT!
All SFP transceivers approved by Siemens support Smart SFP mode. SFP transceivers that do not support
Smart SFP mode may be disabled upon insertion and marked as Unidentified. If this occurs, attempt to
disable Smart SFP and configure the speed and auto-negotiation settings for the port manually.
For information about disabling (or enabling) Smart SFP mode, refer to Section4.17.3, “Enabling/
Disabling Smart SFP Mode (RUGGEDCOM RX5000 Only)”.
Section4.17.2
Viewing SFP Information
To view information about a specific Small Form-Factor Pluggable (SFP) transceiver in a line module, type:
NOTE
Some SFPs may not make information about themselves available. In these cases, a message similar to
the following will appear:
ID: Unknown FF
interfaces switch slot port sfp
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
If an SFP transceiver exists in the selected port, details about the transceiver are displayed. For example:
ruggedcom# interfaces switch lm1 1 sfp
sfp-info-string
ID: SFP or SFP "Plus"
Extended ID: GBIC/SFP function is defined by serial ID only
Connector: LC
Transceiver:
Ethernet Compliance: 100Base-FX
10G Ethernet Compliance: Not specified
Fibre Channel link length: Not specified
Fibre Channel transmitter technology: Not specified
SFP+ cable technology: Not specified
Fibre Channel transmission media: Not specified
Fibre Channel speed: Not specified
Baud Rate, nominal: 100 Mbps
Encoding type: 4B5B
Length(SMF): Not specified
Length(SMF): Not specified
Length(50um): 2000 m
Length(62.5um): 2000 m
Length(Copper): Not specified
Length(OM3): Not specified
Vendor: AVAGO
IEEE company ID: 8193
Part number:
Revision: O
Laser wavelength: 8224 nm
Options: Power Level (see SFF-8431) - level 2
Linear Receiver Output implemented (see SFF-8431)

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English