Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 12
Tunneling and VPNs
Viewing a List of IP Addresses 395
Section12.6.5.1
Viewing a List of IP Addresses
To view a list of remote Layer 2 protocol server IP addresses for a generic tunnel configuration, type:
show running-config tunnel l2tunneld generic tunnel remote-daemon
If tunnels have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config tunnel l2tunneld generic tunnel remote-daemon ip-address | tab
NAME IP ADDRESS
--------------------
1
172.112.10.1
!
If no generic tunnels have been configured, add tunnels as needed. For more information, refer to Section12.6.3,
“Adding a Generic Tunnel”.
Section12.6.5.2
Adding an IP Address
To add the IP address of a remote Layer 2 protocols server to a generic tunnel configuration, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the IP address by typing:
tunnel l2tunneld generic tunnel name remote-daemon ip-address address
Where:
• name is the name of the generic tunnel
• address is the IP address of the remote Layer 2 protocols server
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section12.6.5.3
Deleting an IP Address
To delete the IP address of a remote Layer 2 protocols server from a generic tunnel configuration, do the
following:
1. Make sure the CLI is in Configuration mode.
2. Delete the IP address by typing:
no tunnel l2tunneld generic tunnel name remote-daemon ip-address address
Where:
• name is the name of the generic tunnel
• address is the IP address of the remote Layer 2 protocols server
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English