Siemens RUGGEDCOM ROX II User Manual

Chapter 1
Introduction
RUGGEDCOM ROX II
CLI User Guide
6 Security Recommendations
Feature Key
Feature
Layer 2 Standard
Edition (L2SE)
L3SEL3HW L3SEL2HW L3SECL3HW L3SECL2HW
CLI
ü ü ü ü ü
HTML User Interface
ü ü ü ü ü
MPLS
ü ü ü ü
DHCP
ü ü ü ü
VRRPv2 and VRRPv3
ü ü ü ü
PIM-SM
ü ü ü ü
Firewall
ü ü ü ü
OSPF
ü ü ü ü
BGP
ü ü ü ü
RIP v1/v2
ü ü ü ü
IS-IS
ü ü ü ü
Traffic Prioritization
ü ü ü ü
VPN
ü ü
IPSec
ü ü
Hardware Accelerated Layer 3
Switching
ü ü
Jumbo Frame Support
ü ü
For information about installing and viewing the contents of feature keys, refer to Section4.8, “Managing Feature
Keys”.
Section1.3
Security Recommendations
To prevent unauthorized access to the device, note the following security recommendations:
Authentication
CAUTION!
Accessibility hazard – risk of data loss. Do not misplace the passwords for the device. If both the
maintenance and boot passwords are misplaced, the device must be returned to Siemens Canada Ltd
for repair. This service is not covered under warranty. Depending on the action that must be taken to
regain access to the device, data may be lost.
• Replace the default passwords for all user accounts, access modes (e.g. maintenance mode) and processes
(where applicable) before the device is deployed.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English