Siemens RUGGEDCOM ROX II

RUGGEDCOM ROX II
CLI User Guide
Chapter 17
Time Services
Deleting a Broadcast/Multicast Address 743
Parameter Description
key { key } Synopsis:  A string
Authentication key.
ntp-version { ntp-version } Synopsis:  A 32-bit signed integer between 1 and 4
The version of the NTP protocol used to communicate with this host. Change this only if
it is known that the host requires a version other than 4.
ttl { ttl } Synopsis:  An 8-bit unsigned integer between 1 and 127
Default:  1
Time to live.
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section17.9.3.3
Deleting a Broadcast/Multicast Address
To delete a broadcast/multicast address for an NTP server, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the restriction by typing:
no services ntp broadcast address
Where:
• address is the broadcast or multicast address
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.