Chapter 6
Security
RUGGEDCOM ROX II
CLI User Guide
192 Deleting a Zone
1. Make sure the CLI is in Configuration mode.
2. Add the zone by typing:
security firewall fwconfig firewall fwzone zone
Where:
• firewall is the name of the firewall
• zone is the name of the zone
3. Configure the following parameter(s) as required:
Parameter Description
iptype { iptype } Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Internet protocol type - use both when no addresses are used, otherwise define IPv4 and
IPv6 rules for each type of addresses used.
type46 { type46 } Synopsis: { ip, ipsec, firewall }
Default: ip
Zone types applying to both IPv4 and IPv6: plain IP, firewall, or IPSec
type6 { type6 } Synopsis: { ipv6, ipsec, firewall }
Default: ipv6
Zone types are plain IPv6, firewall, or IPSec
type { type } Synopsis: { ipv4, ipsec, firewall }
Default: ipv4
Zone types are plain IPv4, firewall, or IPSec
description { description } Synopsis: A string
(Optional) The description string for this zone
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section6.9.9.3
Deleting a Zone
To delete a zone, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the zone by typing:
no security firewall fwconfig firewall fwzone name
Where:
• firewall is the name of the firewall
• name is the name of the zone
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
To Next Page
Loading...
Need help?
General
