Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Deleting a Prefix List Distribution Path 473
3. Configure the following parameter(s) as required:
Parameter Description
prefix-list { prefix-list } Synopsis:  A string
The name of the prefix list.
This parameter is mandatory.
4. If necessary, configure an event tracker to track network commands. For more information, refer to
Section13.7.4.2, “Tracking Commands”.
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.7.8.3
Deleting a Prefix List Distribution Path
To delete a prefix list distribution path for dynamic RIP routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the path by typing:
no routing rip distribute-prefix-list direction interface
Where:
• direction is the direction (incoming or outgoing) in which to filter routing updates.
• interface is the name of the interface. This parameter is optional.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.7.9
Managing Key Chains and Keys
Key chains are collections of keys (or shared secrets), which are used to authenticate communications over a
dynamic RIP network. Only routers with the same key are able to send and receive advertisements.
Multiple key chains can be configured for different groups of interfaces and the lifetime for each key within a
chain can be separately configured.
CONTENTS
• Section13.7.9.1, “Viewing a List of Key Chains”
• Section13.7.9.2, “Viewing a List of Keys”
• Section13.7.9.3, “Adding a Key Chain”
• Section13.7.9.4, “Adding a Key”
• Section13.7.9.5, “Deleting a Key Chain”
• Section13.7.9.6, “Deleting a Key”

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English