Siemens RUGGEDCOM ROX II User Manual

Chapter 7
IP Address Assignment
RUGGEDCOM ROX II
CLI User Guide
242 Deleting a Host Group
Parameter Description
The subnet that this host belongs to.
6. [Optional] Configure configuration options for DHCP clients at the host group level. For more information,
refer to refer to Section7.3.5.1, “Configuring Standard DHCP Client Configuration Options (IPv4)” or
Section7.3.5.2, “Configuring Standard DHCP Client Configuration Options (IPv6)”.
7. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.9.4
Deleting a Host Group
To delete a host group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the host group by typing:
• For IPv4
no services dhcpserver host-groups name
• For IPv6
no services dhcpserver6 host-groups name
Where:
• name is the name of the host group
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.10
Managing DHCP Hosts
Host entries assign settings to a specific client based on its Ethernet MAC address.
CONTENTS
• Section7.3.10.1, “Viewing a List of Hosts”
• Section7.3.10.2, “Adding a Host”
• Section7.3.10.3, “Configuring Host Options”
• Section7.3.10.4, “Deleting Hosts”
Section7.3.10.1
Viewing a List of Hosts
To view a list of hosts on the DHCP server, type:
• For IPv4
show running-config services dhcpserver host

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English