Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 16
Traffic Control and Classification
Deleting a NetFlow Interface 723
2. Add the interface by typing:
services netflow interface interface direction direction
Where:
• interface is the desired interface
• direction is the direction of traffic to be monitored. Options include:
▫ ingress – Only traffic entering through the interface is monitored
▫ egress – Only traffic exiting through the interface is monitored
▫ both – All traffic traversing the interface is monitored
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section16.4.7.3
Deleting a NetFlow Interface
To delete a NetFlow interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the interface by typing:
no services netflow interface interface
Where interface is the desired interface.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section16.4.8
Managing NetFlow Collectors
RUGGEDCOM ROX II can be configured to forward flows to up to four NetFlow collectors.
CONTENTS
• Section16.4.8.1, “Viewing a List of NetFlow Collectors”
• Section16.4.8.2, “Adding a NetFlow Collector”
• Section16.4.8.3, “Enabling/Disabling a NetFlow Collector”
• Section16.4.8.4, “Deleting a NetFlow Collector”
Section16.4.8.1
Viewing a List of NetFlow Collectors
To view a list of NetFlow collectors the device can send flows, type:
show running-config services netflow collector
If collectors have been configured, a table or list similar to the following example appears:
show running-config services netflow collector | tab

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English