Siemens RUGGEDCOM ROX II User Manual

Chapter 7
IP Address Assignment
RUGGEDCOM ROX II
CLI User Guide
256 Deleting a Temporary Subnet
services dhcpserver6 subnet6-name name options temporarysubnet6 temporaryname
Where:
• name is the name of the subnet
• temporaryname is the name of the temporary subnet
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.16.3
Deleting a Temporary Subnet
To delete a prefix, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the prefix by typing:
no services dhcpserver6 subnet6-name name options temporarysubnet6 temporaryname
Where:
• name is the name of the subnet
• temporaryname is the temporary subnet
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.17
Managing IPv6 Subnets
One or more optional IPv6 subnets can be defined for the server to offer to the client.
CONTENTS
• Section7.3.17.1, “Viewing a List of IPv6 Subnets”
• Section7.3.17.2, “Adding a IPv6 Subnet”
• Section7.3.17.3, “Deleting an IPv6 Subnet”
Section7.3.17.1
Viewing a List of IPv6 Subnets
To view a list of IPv6 subnets, type:
show running-config services dhcpserver6 subnet6-name name options subnet6
Where:
• name is the name of the subnet
If IPv6 subnets have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services dhcpserver6 subnet6-name sub2 options subnet6
services
dhcpserver6

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English