Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 12
Tunneling and VPNs
Deleting a DMVPN Interface 433
Section12.10.3.3
Deleting a DMVPN Interface
To delete a DMVPN interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the address pool by typing:
no services nhrp interface-nhrp gre-tunnel
Where gre-tunnel is the name of the desired GRE tunnel.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section12.10.4
Viewing the Status of DMVPN
To view the status of the DMVPN service, type:
show services nhrp status
If DMVPN interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show services nhrp status
ROW RAW FROM OPENNHRPCTL
---------------------------------------
0
1 Status: ok
2
3 Interface: gre-gre-1
4 Type: local
5 Protocol-Address: 192.168.0.1/32
6 Flags: up
7
8 Status: ok
9
10 Interface: gre-gre-1
11 Type: static
12 Protocol-Address: 192.168.0.2/24
13 NBMA-Address: 61.1.1.2
14 Flags: up
15
16 Status: ok
17
18 Interface: gre-gre-2
19 Type: local
20 Protocol-Address: 192.168.1.1/32
21 Flags: up
22
23 Status: ok
24
25 Interface: gre-gre-2
26 Type: static
27 Protocol-Address: 192.168.1.2/24
28 NBMA-Address: 71.1.1.2
29 Flags: up
30
Information provided is taken directly from NHRP. The following are some of the fields that may be displayed:

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English