Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Managing Redistribution Metrics 477
Section13.7.10
Managing Redistribution Metrics
Redistribution metrics redistribute routing information from other routing protocols, static routes or routes
handled by the kernel. Routes for subnets that are directly connected to the router, but not part of the RIP
networks, can also be advertised.
CONTENTS
• Section13.7.10.1, “Viewing a List of Redistribution Metrics”
• Section13.7.10.2, “Adding a Redistribution Metric”
• Section13.7.10.3, “Deleting a Redistribution Metric”
Section13.7.10.1
Viewing a List of Redistribution Metrics
To view a list of redistribution metrics for dynamic RIP routes, type:
show running-config routing rip redistribute
If metrics have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing rip redistribute
routing rip
redistribute bgp
no metric
!
!
If no redistribution metrics have been configured, add metrics as needed. For more information, refer to
Section13.7.10.2, “Adding a Redistribution Metric”.
Section13.7.10.2
Adding a Redistribution Metric
To add a redistribution metric for dynamic RIP routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the metric by typing:
routing rip redistribute [ bgp | ospf | connected | static | kernel ]
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.7.10.3
Deleting a Redistribution Metric
To delete a redistribution metric for dynamic RIP routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the metric by typing:

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English