Siemens RUGGEDCOM ROX II User Manual

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
474 Viewing a List of Key Chains
Section13.7.9.1
Viewing a List of Key Chains
To view a list of key chains for dynamic RIP routes, type:
show running-config routing rip key-chain
If key chains have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing rip key-chain
routing rip
key-chain key-1
key 1
key-string RUGGEDCOM
accept-lifetime start 2013-01-01T01:01:01-00:00
accept-lifetime expire 2022-01-01T01:01:01-00:00
send-lifetime start 2013-01-01T01:01:01-00:00
send-lifetime expire 2022-01-01T01:01:01-00:00
!
!
!
If no key chains have been configured, add key chains as needed. For more information, refer to Section13.7.9.3,
“Adding a Key Chain”.
Section13.7.9.2
Viewing a List of Keys
To view a list of keys in a key chain, type:
show running-config routing rip rip key-chain name key
Where:
• name is the name of the key chain
If keys have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing rip key-chain key
routing rip
key-chain key-1
key 1
key-string RUGGEDCOM
accept-lifetime start 2013-01-01T01:01:01-00:00
accept-lifetime expire 2022-01-01T01:01:01-00:00
send-lifetime start 2013-01-01T01:01:01-00:00
send-lifetime expire 2022-01-01T01:01:01-00:00
!
!
!
If no keys have been configured, add keys as needed. For more information, refer to Section13.7.9.4, “Adding a
Key”.
Section13.7.9.3
Adding a Key Chain
To add a key chain for dynamic RIP routes, do the following:

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English