Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 7
IP Address Assignment
Adding a IPv6 Subnet 257
subnet6-name sub2
options
subnet6 2001:db8:28d2::/64
!
!
!
!
!
If no prefixes have been configured, add ranges as needed. For more information, refer to Section7.3.15.2,
“Adding an IPv6 Prefix”.
Section7.3.17.2
Adding a IPv6 Subnet
To add a IPv6 subnet, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the IPv6 subnet by typing:
services dhcpserver6 subnet6-name name options subnet6 subnet6name
Where:
• name is the name of the subnet
• subnet6name is the name of the IPv6 subnet
3. Configure the following parameter(s) as required:
Parameter Description
{ subnet-number } Synopsis:  A string 4 to 43 characters long
The IPv6 subnet that the server uses to offer to the client.
This parameter is mandatory.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.17.3
Deleting an IPv6 Subnet
To delete an IPv6 subnet, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the prefix by typing:
no services dhcpserver6 subnet6-name name options subnet6 subnet6name
Where:
• name is the name of the subnet
• subnet6name is the name of the IPv6 subnet
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English