Siemens RUGGEDCOM ROX II User Manual

Chapter 14
Network Redundancy
RUGGEDCOM ROX II
CLI User Guide
622 Managing Link Failover Parameters
show services link-failover status
A table or list similar to the following appears:
ruggedcom# show services link-failover status
MAIN BACKUP MAIN BACKUP
LINK LINK PING TIME OF LAST STATE INTERFACE
MAIN STATUS STATUS TEST CHANGE LINK BACKUP STATE IN USE
---------------------------------------------------------------------------------------------
switch.0001 up down ok Fri Jan 25 09:49:52 2013 Main path is active fe-1-1
The table or list provides the following information:
Parameter Description
main-link-status Synopsis:  A string
The main link status.
backup-link-status Synopsis:  A string
The backup link status.
main-ping-test Synopsis:  A string
The results of pinging the target using the main interface.
time-of-last-state-change Synopsis:  A string
The time of the last state change.
link-backup-state Synopsis:  A string
The backup link state.
backup-interface-in-use Synopsis:  A string
The name of the backup interface that is being used.
Section14.2.3
Managing Link Failover Parameters
This section describes how to manage parameter settings for link failover.
CONTENTS
• Section14.2.3.1, “Viewing a List of Link Failover Parameters”
• Section14.2.3.2, “Adding a Link Failover Parameter”
• Section14.2.3.3, “Deleting a Link Failover Parameter”
Section14.2.3.1
Viewing a List of Link Failover Parameters
To view a list of link failover parameters, type:
show running-config services link-failover
If parameters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services link-failover
services

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English