Siemens RUGGEDCOM ROX II

Chapter 6
Security
RUGGEDCOM ROX II
CLI User Guide
208 Configuring the Destination Zone
Parameter Description
other { other } Synopsis:  A string
Type a custom definition - this can be a comma-separated list of zones.
all All zones
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section6.9.15.4
Configuring the Destination Zone
To configure the destination zone for a firewall rule, do the following:
1. Make sure the CLI is in Configuration mode.
2. Configure the following parameter(s) as required:
Parameter Description
predefined-zone { predefined-zone } Synopsis:  A string
A pre-defined zone
other { other } Synopsis:  A string
An undefined zone (string).
all All zones
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section6.9.15.5
Deleting a Rule
To delete a rule, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the rule by typing:
no security firewall fwconfig firewall fwrule rule
Where:
• firewall is the name of the firewall
• rule is the name of the rule
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section6.9.16
Validating a Firewall Configuration
To validate a firewall configuration, do the following:
1. Make sure the CLI is in Configuration mode.