Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 7
IP Address Assignment
Configuring Subnet Options 237
Parameter Description
The shared-network that this host belongs to.
Parameter Description
network-ip { network-ip } Synopsis:  A string 4 to 43 characters long
The network IPv6 address for this subnet.
This parameter is mandatory.
shared-network { shared-network } Synopsis:  A string
The shared-network that this host belongs to.
4. Configure the options for the subnet. For more information, refer to Section7.3.8.3, “Configuring Subnet
Options”.
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.8.3
Configuring Subnet Options
To configure options for a subnet, do the following:
NOTE
Options set at the subnet level override options set at the DHCP server level.
1. Make sure the CLI is in Configuration mode.
2. Navigate to:
• For IPv4
services dhcpserver subnet-name name options
• For IPv6
services dhcpserver6 subnet6-name name options
Where:
• name is the name of the subnet
3. Configure the leased time settings by configuring the following parameter(s):
• For IPv4:
Parameter Description
default { default } Synopsis:  A 32-bit unsigned integer
Default:  600
The minimum leased time in seconds that the server offers to the clients.
maximum { maximum } Synopsis:  A 32-bit unsigned integer
Default:  7200
The maximum leased time in seconds that the server offers to the clients.
• For IPv6:
Parameter Description
default { default } Synopsis:  A 32-bit unsigned integer
Default:  600

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English