Siemens RUGGEDCOM ROX II

RUGGEDCOM ROX II
CLI User Guide
Chapter 10
Serial Server
Managing Remote Hosts 347
loopback true
For more information, refer to Section10.6.2, “Adding a Local Host”
13. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
14. Verify the configuration by typing the following:
traceserial
Final Configuration Example
Serial Port 1 Configuration
serial lm1 1
no alias
protocols rawsocket
setrawsocket local-port 10001
setrawsocket transport udp
setrawsocket remote-host 232.1.1.1 5001
loopback true
interface switch.0010
!
interface switch.0020
Serial Port 2 Configuration
serial lm1 2
no alias
protocols rawsocket
setrawsocket local-port 5001
setrawsocket transport udp
setrawsocket local-host 232.1.1.1
loopback true
Section10.5
Managing Remote Hosts
Remote hosts are required when the UDP transport connection protocol is selected for the raw socket protocol.
CONTENTS
• Section10.5.1, “Viewing a List of Remote Hosts”
• Section10.5.2, “Adding a Remote Host”
• Section10.5.3, “Deleting a Remote Host”
Section10.5.1
Viewing a List of Remote Hosts
To view a list of remote hosts configured for a serial port using the raw socket protocol, type:
show running-config interface serial protocols rawsocket setrawsocket remote-host
If hosts have been configured, a table or list similar to the following example appears: