Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Deleting an Interface for an IPv4 Static Route 587
2. Add the gateway address by typing:
routing ipv4 route subnet dev interface
Where:
• subnet is the subnet (network/prefix) of the static route
• interface is the name of the interface for the static route
3. Configure the following parameter(s) as required:
Parameter Description
distance { distance } Synopsis:  A 32-bit unsigned integer between 1 and 255
The distance for the static route.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.12.7.4
Deleting an Interface for an IPv4 Static Route
To delete an interface for an IPv4 static route, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the gateway address by typing:
no routing ipv4 route subnet dev interface
Where:
• subnet is the subnet (network/prefix) of the static route
• interface is the name of the interface for the static route
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.13
Managing Static Multicast Routing
Static multicast routing allows network designers to control the flow of multicast traffic by manually adding static
routes to the routing table.
CONTENTS
• Section13.13.1, “Enabling/Disabling Static Multicast Routing”
• Section13.13.2, “Managing Static Multicast Groups”
• Section13.13.3, “Managing Out-Interfaces”
Section13.13.1
Enabling/Disabling Static Multicast Routing
To enable or disable static multicast routing, do the following:

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English