RUGGEDCOM ROX II
CLI User Guide
Chapter 16
Traffic Control and Classification
Deleting a Traffic Control Device 701
Parameter Description
Maximum outgoing bandwidth... This is the maximum speed that can be handled.
Additional packets will be dropped. This is the bandwidth that can be refrred-to as 'full'
when defining classes.
This parameter is mandatory.
out-unit { out-unit } Synopsis: { kilobits, megabits }
Default: megabits
Unit for outgoing bandwidth, per second.
description { description } Synopsis: A string
A description for this configuration item.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section16.2.5.3
Deleting a Traffic Control Device
To delete a traffic control device, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the traffic control device by typing:
no qos traffic-control advanced-configuration tcdevices name
Where:
• name is the name of the interface to which traffic shaping will apply.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section16.2.6
Managing Traffic Control Rules
Traffic control rules define rules for packet marking.
NOTE
Traffic control rules can only be configured in advanced mode. For more information about setting the
traffic control mode, refer to Section16.2.1, “Enabling and Configuring Traffic Control”.
CONTENTS
• Section16.2.6.1, “Viewing a List of Traffic Control Rules”
• Section16.2.6.2, “Adding a Traffic Control Rule”
• Section16.2.6.3, “Configuring QoS Marking”
• Section16.2.6.4, “Deleting aTraffic Control Rule”
To Next Page
Loading...
Need help?
General
