Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 4
Device Management
Viewing CPU/RAM Utilization 59
Parameter Description
This parameter is mandatory.
Section4.2.4
Viewing CPU/RAM Utilization
To view the CPU/RAM utilization statistics for each module installed in the device, type:
show chassis cpu slot-cpu
A table or list similar to the following example appears:
ruggedcom# show chassis cpu slot-cpu | tab
RAM
CPU RAM AVAIL
SLOT DETECTED MODULE LOAD AVAIL LOW
-------------------------------------------------------------------------
lm3 16x 10/100TX RJ45 0 74 70
cm RX5000 Control Module 17 59 57
sm SM 8 Gigabit Layer 2 w/ 2x 10/100/1000TX RJ45 0 74 71
lm4 8x 100FX SFP 8 74 70
This table or list provides the following information:
Parameter Description
slot Synopsis:  { { --- }{ pm1, pm2, main }{ sm, lm1, lm2, lm3, lm4, lm5, lm6, swport, eth,
serport, celport, wlanport }{ cm, em }{ trnk } }
The slot name, as marked on the silkscreen across the top of the chassis.
detected-module Synopsis:  A string 1 to 60 characters long
The installed module's type specifier.
This parameter is mandatory.
cpu-load Synopsis:  A 32-bit signed integer between 0 and 100
The CPU load, in percent, on the installed module.
ram-avail Synopsis:  A 32-bit signed integer between 0 and 100
The proportion of memory (RAM) currently unused, in percent, on the installed module.
ram-avail-low Synopsis:  A 32-bit signed integer between 0 and 100
The lowest proportion of unused memory (RAM), in percent, recorded for the installed
module since start-up.
Section4.2.5
Viewing the Slot Status
To view the overall status of each slot, type:
show chassis status slot-status
A table or list similar to the following example appears:
ruggedcom# show chassis status slot-status | tab
STATUS
START

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English