Siemens RUGGEDCOM ROX II User Manual

Chapter 15
Network Discovery and Management
RUGGEDCOM ROX II
CLI User Guide
680 Managing SNMP Security Model Mapping
no admin snmp snmp-user id name
Where:
• id is the ID for the user
• name is the name of the user
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section15.2.8
Managing SNMP Security Model Mapping
This section describes how to manage the mapping of SNMP security models.
CONTENTS
• Section15.2.8.1, “Viewing a List of SNMP Security Models”
• Section15.2.8.2, “Adding an SNMP Security Model”
• Section15.2.8.3, “Deleting an SNMP Security Model”
Section15.2.8.1
Viewing a List of SNMP Security Models
To view a list of SNMP security models configured on the device, type:
show running-config admin snmp snmp-security-to-group
If target addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin snmp snmp-security-to-group | tab
SECURITY USER
MODEL NAME GROUP
-----------------------------
v1 oper all-rights
v1 guest all-rights
v2c oper all-rights
v2c admin testgroup
v2c guest all-rights
v3 admin initial
!
!
If no SNMP security models have been configured, add security models as needed. For more information, refer to
Section15.2.8.2, “Adding an SNMP Security Model”.
Section15.2.8.2
Adding an SNMP Security Model
To add an SNMP security model, do the following:
1. Make sure the CLI is in Configuration mode.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English