Siemens RUGGEDCOM ROX II User Manual

Chapter 10
Serial Server
RUGGEDCOM ROX II
CLI User Guide
338 Managing Serial Multicast Streaming
no interface serial slot port protocols dnp setdnp device-table address
Where:
• slot is the name of the module location.
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module.
• address is the local or remote DNP device address. The address may be that of a DNP device connected to
a local serial port or one available via the serial port of a remote IP host.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section10.4
Managing Serial Multicast Streaming
RUGGEDCOM ROX II supports the ingress and egress of raw-socket UDP serial multicast streams.
This section describes how to configure and manage serial multicast streaming.
CONTENTS
• Section10.4.1, “Understanding Serial Multicast Streaming”
• Section10.4.2, “Configuring Serial Multicast Streaming”
• Section10.4.3, “Example: Serial Interfaces Configured as a Sink for Multicast Streams”
• Section10.4.4, “Example: Serial Interfaces Configured as a Source for Multicast Streams”
• Section10.4.5, “Example: Serial Interfaces Configured as a Source and Sink for Multicast Streams”
Section10.4.1
Understanding Serial Multicast Streaming
Serial multicast streaming allows the transport of serial data streams to individual or groups of remote hosts via
the UDP protocol.
An Ethernet multicast stream consists of a multicast group IP address (e.g. 232.1.1.1), destination UDP port (e.g. 1
to 65535) and an interface.
A serial port can act as both:
• A sink for data coming from IP multicast streams
• A source of data to be transmitted to multiple IP multicast receivers
CONTENTS
• Section10.4.1.1, “Sink vs. Source Ports”
• Section10.4.1.2, “Multicast Streaming Examples”

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English