Siemens RUGGEDCOM ROX II User Manual

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
458 Viewing a List of NETs
IMPORTANT!
The system identifier must be unique to the network.
CONTENTS
• Section13.6.11.1, “Viewing a List of NETs”
• Section13.6.11.2, “Adding a NET”
• Section13.6.11.3, “Deleting a NET”
Section13.6.11.1
Viewing a List of NETs
To view a list of areas configured for dynamic IS-IS routes, type:
show running-config routing isis area name net
Where:
• name is the unique name for a routing process that belongs to a specific router.
If NETs have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing isis area Area_1 net | tab
NET TITLE
---------------------------
49.0001.1921.6800.1001.00
!
!
If no NETs have been configured, add NETs as needed. For more information, refer to Section13.6.11.2, “Adding a
NET”.
Section13.6.11.2
Adding a NET
To add a Network Entity Title (NET) for an IS-IS area, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the NET by typing:
routing isis area name net title
Where:
• name is the unique name for a routing process that belongs to a specific router.
• title is the NET for the router, consisting of a two-octet area ID, a three-octet system ID and a one-octet
selector. For example: 0001.1921.6800.1001.00
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English