Siemens RUGGEDCOM ROX II

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
536 Managing Redistribution Metrics
Section13.9.8
Managing Redistribution Metrics
Redistribution metrics redistribute routing information from other routing protocols, static routes or routes
handled by the kernel. Routes for subnets that are directly connected to the router, but not part of the OSPF areas,
can also be advertised.
CONTENTS
• Section13.9.8.1, “Viewing a List of Redistribution Metrics”
• Section13.9.8.2, “Adding a Redistribution Metric”
• Section13.9.8.3, “Deleting a Redistribution Metric”
Section13.9.8.1
Viewing a List of Redistribution Metrics
To view a list of redistribution metrics for dynamic OSPF routes, type:
• For Standard OSPF Routes
routing ospf redistribute
• For VRF Routes via OSPF
routing ospf vrf vrf redistribute
Where:
• vrf is the name of the chosen VRF
If metrics have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf redistribute
routing ospf
redistribute bgp
no metric-type
no metric
!
!
If no redistribution metrics have been configured, add metrics as needed. For more information, refer to
Section13.9.8.2, “Adding a Redistribution Metric”.
Section13.9.8.2
Adding a Redistribution Metric
To add a redistribution metric for dynamic OSPF routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the metric by typing:
• For Standard OSPF Routes
routing ospf redistribute [ bgp | rip | connected | static | kernel ]
• For VRF Routes via OSPF
routing ospf vrf vrf redistribute [ bgp | rip | connected | static | kernel ]