Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 7
IP Address Assignment
Deleting an Address Pool (IPv4) 247
Where:
• name is the name of the subnet
• description is the name of the IP pool
3. Configure the leased time settings by configuring the following parameter(s):
Parameter Description
default { default } Synopsis:  A 32-bit unsigned integer
Default:  600
The minimum leased time in seconds that the server offers to the clients.
maximum { maximum } Synopsis:  A 32-bit unsigned integer
Default:  7200
The maximum leased time in seconds that the server offers to the clients.
4. Configure the client and failover settings by configuring the following parameter(s):
Parameter Description
unknown-client { unknown-client } Synopsis:  { allow, deny, ignore }
The action to take for previously unregistered clients
failover-peer { failover-peer } Synopsis:  A string 7 to 15 characters long
The IP address of a DHCP peer server if a failover pool is created.
5. Add one or more IP ranges to the pool. For more information, refer to Section7.3.13.2, “Adding an IP Range
(IPv4)”.
6. Add one or more Option82 classes to the pool. For more information, refer to Section7.3.18.2, “Adding an
Option 82 Class to an Address Pool”.
7. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.11.3
Deleting an Address Pool (IPv4)
To delete an address pool, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the address pool by typing:
no services dhcpserver subnet-name name options ippool description
Where:
• name is the name of the subnet
• description is the name of the IP pool
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English