Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 10
Serial Server
Deleting a Remote Host 349
Section10.5.3
Deleting a Remote Host
To delete a remote host, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the remote host by typing:
no interface serial slot port protocols rawsocket setrawsocket remote-host address remote-port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• address is the IP address for the remote host
• remote-port is the port number for the remote host
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section10.6
Managing Local Hosts
Local hosts are required when the UDP transport connection protocol is selected and multicast streams are to be
received for the raw socket protocol.
CONTENTS
• Section10.6.1, “Viewing a List of Local Hosts”
• Section10.6.2, “Adding a Local Host”
• Section10.6.3, “Deleting a Local Host”
Section10.6.1
Viewing a List of Local Hosts
To view a list of local hosts configured for a serial port using the raw socket protocol, type:
show running-config interface serial protocols rawsocket setrawsocket local-host
If hosts have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface serial protocols rawsocket setrawsocket local-host
interface
serial lm5 1
protocols rawsocket
setrawsocket local-host 224.1.2.1
interface ge-4-4
!
!
!
!
!

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English