Siemens RUGGEDCOM ROX II User Manual

Chapter 6
Security
RUGGEDCOM ROX II
CLI User Guide
140 Configuring RADIUS Authentication for PPP Services
IMPORTANT!
Passwords are case-sensitive.
1. Make sure the CLI is in Configuration mode.
2. Type the following:
admin authentication radius
3. [Optional] If port security is enabled on any ports, configuring the following parameter(s) to avoid conflicts
with firewall rules/policies:
Parameter Description
nas-ip-address { nas-ip-address } Synopsis:  A string 7 to 15 characters long or a string 6 to 40 characters long
The NAS-IP-Address. Set this to the primary IP address of the unit.
nas-identifier { nas-identifier } Synopsis:  A string 1 to 64 characters long
The NAS-Identifier. If not set, the hostname will be used as the NAS-Identifier.
4. Configure the primary or secondary RADIUS server by typing either primary or secondary and configuring
the following parameter(s) as required:
Parameter Description
address { address } Synopsis:  A string 7 to 15 characters long or a string 6 to 40 characters long
The IP address of the server.
port-udp { port-udp } Synopsis:  A 32-bit signed integer between 1 and 65535
Default:  1812
The network port of the server.
password { password } Synopsis:  A string
The password of the RADIUS server.
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section6.7.3.2
Configuring RADIUS Authentication for PPP Services
To configure RADIUS authentication for PPP services, do the following:
IMPORTANT!
Passwords are case-sensitive.
1. Make sure the CLI is in Configuration mode.
2. Type the following:
global ppp radius
3. Configure the primary or secondary RADIUS server by typing either primary or secondary and configuring
the following parameter(s) as required:
Parameter Description
address { address } Synopsis:  A string 7 to 15 characters long

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English