Siemens RUGGEDCOM ROX II

RUGGEDCOM ROX II
CLI User Guide
Chapter 7
IP Address Assignment
Deleting an Address Pool (IPv6) 249
• ippoolname is the name of the IPv6 pool
3. Configure the leased time settings by configuring the following parameter(s):
Parameter Description
default { default } Synopsis:  A 32-bit unsigned integer
Default:  600
The minimum leased time in seconds that the server offers to the clients.
maximum { maximum } Synopsis:  A 32-bit unsigned integer
Default:  7200
The maximum leased time in seconds that the server offers to the clients.
4. Configure the client and failover settings by configuring the following parameter(s):
Parameter Description
unknown-client { unknown-client } Synopsis:  { allow, deny, ignore }
The action to take for previously unregistered clients
5. [Optional] Add one or more IP ranges to the pool. For more information, refer to Section7.3.14.2, “Adding an
IP Range (IPv6)”.
6. [Optional] Add one or more subnets to the pool. For more information, refer to Section7.3.17.2, “Adding a
IPv6 Subnet”.
7. [Optional] Add one or more temporary subnets to the pool. For more information, refer to Section7.3.16.2,
“Adding a Temporary Subnet”.
8. [Optional] Add one or more prefixes to the pool. For more information, refer to Section7.3.15.2, “Adding an
IPv6 Prefix”.
9. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.12.3
Deleting an Address Pool (IPv6)
To delete an address pool, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the address pool by typing:
no services dhcpserver subnet6-name name options ippool6 ippoolname
Where:
• name is the name of the subnet
• ippoolname is the name of the IPv6 pool
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.