Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Adding a Static Multicast Group 589
Section13.13.2.2
Adding a Static Multicast Group
To add a static multicast group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the multicast group by typing:
routing multicast static mcast-groups description
Where:
• description is the name of the multicast group. Up to 32 characters are allowed, excluding spaces.
3. Configure the following parameter(s) as required:
Parameter Description
{ description } Synopsis:  A string 1 to 32 characters long
Describes the multicast group, spaces are not allowed.
4. Configure out-interfaces. Refer to Section13.13.3.2, “Adding an Out-Interface”.
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.13.2.3
Deleting a Static Multicast Group
To delete a static multicast group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the multicast group by typing:
no routing multicast static mcast-groups description
Where:
• description is the name of the multicast group to be deleted
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.13.3
Managing Out-Interfaces
An out-interface is the interface to which multicast packets are forwarded. Multiple out-interfaces can be defined
for each static multicast group.
CONTENTS
• Section13.13.3.1, “Viewing a List of Out-Interfaces”
• Section13.13.3.2, “Adding an Out-Interface”
• Section13.13.3.3, “Deleting an Out-Interface”

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English