Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 8
Layer 2
Managing Forbidden Ports 313
Where:
• id is the ID of the VLAN
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section8.5.6
Managing Forbidden Ports
Static VLANs can be configured to exclude ports from membership in the VLAN using the forbidden ports list.
CONTENTS
• Section8.5.6.1, “Viewing a List of Forbidden Ports”
• Section8.5.6.2, “Adding a Forbidden Port”
• Section8.5.6.3, “Deleting a Forbidden Port”
Section8.5.6.1
Viewing a List of Forbidden Ports
To view a list of forbidden ports, type:
show running-config switch vlans static-vlan forbidden-ports
If ports have been forbidden, a table or list similar to the following example appears:
ruggedcom# show running-config switch vlans static-vlan forbidden-ports | tab
VID SLOT PORT
-----------------
50
lm1 1
lm1 2
60
lm1 2
lm1 3
lm1 4
70
lm1 5
!
If no ports have been forbidden, add forbidden ports as needed. For more information, refer to Section8.5.6.2,
“Adding a Forbidden Port”.
Section8.5.6.2
Adding a Forbidden Port
To add a forbidden port, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the forbidden port by typing:
switch vlans static-vlan name forbidden-ports slot port

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English