Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 4
Device Management
Shutting Down the Device 63
RX5000 4FG05 12-86-0015-001 4x 1000LX Singlemode 1310nm LC 25km
12-86-0202-042
12-86-0202-042
RX5000 4FG50 12-86-0015-001 4x 1000LX SFP
12-86-0201-001
12-86-0201-001
RX5000 4FX01 12-86-0018-002 4x 100FX Multimode ST 2km
RX5000 4FX02 12-86-0018-001 4x 100FX Multimode SC 2km
RX5000 4FX03 12-86-0018-003 4x 100FX Multimode MTRJ 2km
RX5000 4FX04 12-86-0018-006 4x 100FX Singlemode 1310nm ST 20km
RX5000 4FX05 12-86-0018-005 4x 100FX Singlemode 1310nm SC 20km
RX5000 4FX06 12-86-0018-007 4x 100FX Singlemode 1310nm LC 20km
RX5000 4FX07 12-86-0018-008 4x 100FX Singlemode 1310nm SC 50km
.
.
.
Section4.4
Shutting Down the Device
To shut down the device, type:
CAUTION!
Security hazard – risk of unauthorized access and/or exploitation. Always shutdown the device before
disconnecting power. Failure to shutdown the device first could result in data corruption.
NOTE
The device never enters a permanent shutdown state. When instructed to shutdown, the devices shuts
down and provides a time-out period during which power can be disconnected from the device. The
default time-out period is 300 seconds (five minutes). At the end of the time-out period, the device
reboots and restarts.
NOTE
If wiring hinders the process of disconnecting power from the device, the power module(s) can be
removed instead.
admin shutdown
Section4.5
Rebooting the Device
To reboot the device, type:
admin reboot

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English