Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 4
Device Management
Managing Feature Keys 65
Section4.8
Managing Feature Keys
RUGGEDCOM ROX II can be enhanced with additional features at any time by adding feature levels. Feature
levels are encoded in feature keys that can be loaded on a device. At the time of ordering, a device feature key
is encoded into the electronic signature of the device. This feature key is independent of the compact flash card
or USB Mass Storage drive, and is retained by the device itself should the card be replaced. Additional file-based
feature keys can be added as needed.
NOTE
Some RUGGEDCOM ROX II features are only available through the purchase of feature levels. For more
information about the available feature levels, refer to the product data sheet for the device available
at https://www.siemens.com/ruggedcom or contact a Siemens Sales representative.
NOTE
File-based feature keys can be used on different devices. To tie a feature key to a specific device,
contact a Siemens Canada Ltd Sales representative to arrange for an RMA (Return to Manufacturer
Authorization) to program the feature key into the device.
When ordering feature levels, make sure to provide the main serial numberand cm serial number for the device.
An upgraded feature key file will be provided that is licensed to the device. For information on how to determine
the main serial numberand cm serial number, refer to Section4.1, “Displaying Device and Software Information”.
CONTENTS
• Section4.8.1, “Viewing the Contents of a Feature Key”
• Section4.8.2, “Installing Feature Keys”
Section4.8.1
Viewing the Contents of a Feature Key
To view the contents of a feature key saved on the device, do the following:
1. Make sure the CLI is in Operational mode.
2. At the command prompt, type:
file show-featurekey filename
Where:
• filename is the name of feature key file stored on the device
For example:
ruggedcom# file show-featurekey 1_cmRX1K-12-11-0015.key
3. Press Enter. The system displays the contents of the feature key file. For example:
ruggedcom# file show-featurekey L3SE_cmRUMHD06096338.key
GPG_FEATUREKEY_LEVEL=L3SE
GPG_FEATUREKEY_CM_SERIALNUMBER=RUMHD06096338
GPG_FEATUREKEY_SIGNATURE=iEYEABECAAYFAliGF4EACgkQP2pya+G5kdYj1ACfecKysp3DK3QBsP87I/
gXgi92cwAAnjqrsgdqwaCczY4ghWrR0ELkr2TK

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English