RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Deleting an Event Tracker 441
Parameter Description
The number of times a failure occurs before changing the tracking state from up to
down.
This parameter is mandatory.
rise { rise } Synopsis: A 32-bit unsigned integer equaling 1 or higher
The number of times success occurs before changing the tracking state from down to up.
state Synopsis: { up, down }
Default: up
The state of the event.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.5.4
Deleting an Event Tracker
To delete an event tracker, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the event tracker by typing:
no global tracking event name
• name is the name of the tracking event
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.6
Managing IS-IS
Intermediate System - Intermediate System (IS-IS) is one of a suite of routing protocols tasked with sharing routing
information between routers. The job of the router is to enable the efficient movement of data over sometimes
complex networks. Routing protocols are designed to share routing information across these networks and use
sophisticated algorithms to decide the shortest route for the information to travel from point A to point B. One
of the first link-state routing protocols was IS-IS developed in 1986 and later published in 1987 by ISO as ISO/IEC
10589. It was later republished as an IETF standard (RFC 1142 [http://tools.ietf.org/html/rfc1142]).
CONTENTS
• Section13.6.1, “IS-IS Concepts”
• Section13.6.2, “Configuring IS-IS”
• Section13.6.3, “Viewing the Status of Neighbors”
• Section13.6.4, “Viewing the Status of the Link-State Database”
• Section13.6.5, “Managing Area Tags”
• Section13.6.6, “Managing Interfaces”
• Section13.6.7, “Managing LSP Generation”
• Section13.6.8, “Managing SPF Calculations”
To Next Page
Loading...
Need help?
General
