RUGGEDCOM ROX II
CLI User Guide
Chapter 6
Security
Managing CA Certificates for the Trusted Certificate Store 171
Issued: Oct 1 00:00:00 1999 GMT
Expires: Jul 16 23:59:59 2036 GMT
Section6.8.3
Managing CA Certificates for the Trusted Certificate Store
To establish trust between the device and an endpoint (e.g. server, portal, etc.), add the necessary CA certificates
to the Trusted Certificate Store.
CONTENTS
• Section6.8.3.1, “Viewing a List of CA Certificates Added to the Trusted Certificate Store”
• Section6.8.3.2, “Adding a CA Certificate to the Trusted Certificate Store”
• Section6.8.3.3, “Deleting a CA Certificate from the Trusted Certificate Store”
Section6.8.3.1
Viewing a List of CA Certificates Added to the Trusted Certificate Store
To view a list of CA certificates added to the Trusted Certificate Store, type:
show admin system-ca-certificates configured-cas
If CA certificates have been added to the Store, a table or list similar to the following example appears:
ruggedcom# show running-config admin system-ca-certificates configured-cas | tab
NAME
------
cert
!
If no CA certificates have been added to the Store, add certificates as needed. For more information, refer to
Section6.8.3.2, “Adding a CA Certificate to the Trusted Certificate Store”.
Section6.8.3.2
Adding a CA Certificate to the Trusted Certificate Store
To add a CA certificate to the Trusted Certificate Store, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the CA certificate by typing:
admin system-ca-certificates configured-cas certificate
Where certificate is the chosen CA certificate.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
To Next Page
Loading...
Need help?
General
