RUGGEDCOM ROX II
CLI User Guide
Chapter 4
Device Management
Managing Files 67
• path is the directory path to the feature key file on the USB Mass Storage drive.
• current-filename is the current name of the feature key file.
• new-filename is the new name of the feature key file on the device. This parameter is optional. The
current filename will be used if a new filename is not provided.
For example:
file scp-featurekey-from-url usb://repository/keys/L3SE_cmRUMHD06096338.key
L3SE_cmRUMHD06096338.key
The system uploads the feature key file:
ruggedcom# file scp-featurekey-from-url usb://repository/keys/
L3SE_cmRUMHD06096338.key L3SE_cmRUMHD06096338.key
L3SE_cmRUMHD06096338.key 100% 192 0.2KB/s 00:00
Section4.9
Managing Files
RUGGEDCOM ROX II allows the transfer of select files to and from the device using the following methods:
• Install
Allows users to upload files from a USB flash drive or from a remote server using a file transfer protocol, such as
FTP.
• Backup
Allows users to download files to a USB flash drive or to a remote server using a file transfer protocol, such as
FTP.
CONTENTS
• Section4.9.1, “Installing Files”
• Section4.9.2, “Backing Up Files”
Section4.9.1
Installing Files
To install a file on the device, such as a configuration file or feature key, do the following:
1. If the source of the file is a USB Mass Storage drive, insert the drive in the USB port on the device. For more
information, refer to the RUGGEDCOM RX5000/MX5000/MX5000RE Installation Guide.
2. Navigate to admin» install-files and configure the following parameter(s) as required:
NOTE
RUGGEDCOM ROX II supports implicit FTP over TLS (FTPS) URLs. Explicit FTP over TLS is not
supported.
Parameter Description
file-type { file-type } Synopsis: { config, featurekey, vmfile }
The file types to be copied.
To Next Page
Loading...
Need help?
General
