Chapter 5
System Administration
RUGGEDCOM ROX II
CLI User Guide
104 Configuring the Host Name
Parameter Description
The textual identification of the contact person for this managed node, together with
information on how to contact this person. If no contact information is known, the value
is the zero-length string.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section5.2
Configuring the Host Name
To configure the host name for the device, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to admin» hostname and configure the following parameter(s) as required:
IMPORTANT!
Special characters (i.e. !@#$%^&*()_+-={}[];:',<.>/?\|`~) are not permitted in host names.
Parameter Description
name { name } Synopsis: A string 1 to 63 characters long
Default: ruggedcom
The host name for the device. This name appears in the command line prompt. The host
name must not contain special characters (i.e.\!@#$%^&*()_+-={}[];:',<.>/?\\|`~).
domain { domain } Synopsis: A string 1 to 253 characters long
Default: localdomain
The domain name associated with the device. This name is appended to the end of
unqualified names (e.g. ruggedcom.example.com).
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section5.3
Customizing the Welcome Screen
A custom welcome message for both the Web and CLI interfaces can be displayed at the login prompt.
To add a welcome message, type:
admin authentication banner message
Where:
• message is the custom welcome message
Section5.4
Setting the Maximum Number of Sessions
To set the maximum number of sessions that can be open at one time, do the following:
To Next Page
Loading...
Need help?
General
