Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 8
Layer 2
Adding an Ethernet Trunk Interface 281
!
!
If no Ethernet trunk interfaces have been configured, add trunks as needed. For more information, refer to
Section8.2.2, “Adding an Ethernet Trunk Interface”.
Section8.2.2
Adding an Ethernet Trunk Interface
To add an Ethernet trunk interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the interface by typing:
interface trunks id
Where:
• id is the ID given to the trunk
3. Configure the interface by typing the following commands:
Parameter Description
switchport Synopsis:  { true, false }
The physical port into either Switched mode or a dedicated Routing mode.
on-demand Bring up this interface on-demand only
ip-address-src { ip-address-src } Synopsis:  { static, dynamic }
Whether the IP address is static or dynamically assigned via DHCP or BOOTP. Option
DYNAMIC is a common case of a dynamically assigned IP address. It switches between
BOOTP and DHCP until it gets the response from the relevant server. This must be static
for non-management interfaces.
ipv6-address-src { ipv6-address-src } Synopsis:  { static, dynamic }
Default:  static
Whether the IP address is static or dynamically assigned via DHCP. Option DYNAMIC
is a common case of a dynamically assigned IP address. This must be static for non-
management interfaces.
proxyarp Enables/Disables whether the VLAN will respond to ARP requests for hosts other than
itself
mtu { mtu } Synopsis:  A 32-bit signed integer between 68 and 9216
Default:  1500
Maximum transmission unit (largest packet size allowed for this interface).
alias { alias } Synopsis:  A string 1 to 64 characters long
The SNMP alias name of the interface
4. Configure the multicast filtering settings by typing the following commands:
Parameter Description
gmrp { gmrp } Synopsis:  { advertise_only, learn_advertise }
GMRP (GARP Multicast Registration Protocol) operation on the port. There are several
GMRP operation modes:
• DISABLED : the port is not capable of any GMRP processing.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English