Siemens RUGGEDCOM ROX II User Manual

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
534 Managing Incoming Route Filters
Parameter Description
prefix-list { prefix-list } Synopsis:  A string
The prefix list name.
Parameter Description
prefix-list { prefix-list } Synopsis:  A string
The prefix list name.
Parameter Description
ifname { ifname } Synopsis:  A string
The interface name.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.9.7
Managing Incoming Route Filters
Incoming route advertisements can be filtered by assigning one or route map filters. This can be useful for
excluding specific OSPF routes from the routing table.
NOTE
For more information about route map filters, refer to Section13.9.6, “Managing Route Maps”.
CONTENTS
• Section13.9.7.1, “Viewing List of Incoming Route Filters”
• Section13.9.7.2, “Adding an Incoming Route Filter”
• Section13.9.7.3, “Deleting an Incoming Route Filter”
Section13.9.7.1
Viewing List of Incoming Route Filters
To view a list of route filters configured for incoming advertised routes, type:
• For Standard OSPF Routes
show running-config routing ospf incoming-route-filter
• For VRF Routes via OSPF
show running-config routing ospf vrf vrf incoming-route-filter
Where:
• vrf is the name of the chosen VRF
If route filters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf incoming-route-filter
routing ospf
incoming-route-filter ospf_route_1

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English