Siemens RUGGEDCOM ROX II - 7.3.6.2. Adding a DHCP Listen Interface; 7.3.6.3. Deleting a DHCP Listen Interface; 7.3.7. Managing Shared Networks

Chapter 7
IP Address Assignment
RUGGEDCOM ROX II
CLI User Guide
232 Adding a DHCP Listen Interface
!
!
If no DHCP listen interfaces have been configured, add interfaces as needed. For more information, refer to
Section7.3.6.2, “Adding a DHCP Listen Interface”.
Section7.3.6.2
Adding a DHCP Listen Interface
To add a DHCP listen interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the interface by typing:
• For IPv4
services dhcpserver interface name
• For IPv6
services dhcpserver6 interface name
Where:
• name is the name of the interface
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.6.3
Deleting a DHCP Listen Interface
To delete a DHCP listen interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the interface by typing:
• For IPv4
no services dhcpserver interface name
• For IPv6
no services dhcpserver6 interface name
Where:
• name is the name of the interface
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.3.7
Managing Shared Networks
Shared networks are used when multiple subnets should be served by a single physical port. This applies both
when using a DHCP relay agent connected to the port with additional subnets behind the relay agent, or when