Siemens RUGGEDCOM ROX II User Manual

Chapter 7
IP Address Assignment
RUGGEDCOM ROX II
CLI User Guide
214 Adding an IPv4 Address
192.168.0.12/24 -
172.30.150.12/19 -
switch.0001
switch.0011
192.168.11.1/24 -
switch.0012
192.168.12.1/24 -
switch.0014
192.168.14.1/24 -
If no addresses have been configured, add addresses as needed. For more information, refer to Section7.1.3.2,
“Adding an IPv4 Address”.
Section7.1.3.2
Adding an IPv4 Address
To add an IPv4 address to a routable interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the address by typing:
ip interface ipv4 address address peer peer
Where:
• interface is the name of the interface
• address is the IPv4 address and prefix
• peer is the peer IPv4 address
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.1.3.3
Deleting an IPv4 Address
To delete an IPv4 address for a routable interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the address by typing:
no ip interface ipv4 address address
Where:
• address is the IPv4 address
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English