Siemens RUGGEDCOM ROX II User Manual

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
522 Viewing the Status of Dynamic OSPF Routes
Parameter Description
opaque-lsa Enables the Opaque-LSA capability (RFC2370).
passive-default Synopsis:  { true, false }
Default:  true
Default passive value for new interface.
refresh-timer { refresh-timer } Synopsis:  A 16-bit unsigned integer between 10 and 1800
Default:  10
The refresh timer.
router-id { router-id } Synopsis:  A string 7 to 15 characters long
The Router ID for OSPF.
3. Configure prefix list filters. For more information, refer to Section13.9.4.3, “Adding a Prefix List”.
4. Configure areas. For more information, refer to Section13.9.5.2, “Adding an Area”.
5. Configure route map filters. For more information, refer to Section13.9.6.3, “Adding a Route Map Filter”.
6. Configure redistribution metrics. For more information, refer to Section13.9.8.2, “Adding a Redistribution
Metric”.
7. Configure interfaces. For more information, refer to Section13.9.9.2, “Configuring a Routing Interface”.
8. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section13.9.3
Viewing the Status of Dynamic OSPF Routes
To view the status of the dynamic OSPF routes configured on the device, type:
show routing status ospf route network
If OSPF routes have been configured, a table or list similar to the following example appears:
ruggedcom# show routing status ospf route network | tab
ID DISCARD INTER AREA COST AREA HOW
---------------------------------------------------------------------------------
192.168.1.0/24 no intra area 10 0.0.0.0
directly attached to fe-1-2
192.168.2.0/24 no intra area 10 0.0.0.0
directly attached to fe-1-4
This list provides the following information:
Parameter Description
id Synopsis:  A string
Network Prefix.
destination Synopsis:  A string
Destination (network or discard).
path-type Synopsis:  A string
Path type (inter-area or intra-area).
cost Synopsis:  A string
Cost.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English