Siemens RUGGEDCOM ROX II User Manual

Chapter 12
Tunneling and VPNs
RUGGEDCOM ROX II
CLI User Guide
390 Deleting a GOOSE Tunnel
tunnel l2tunneld goose tunnel name
Where:
• name is the name of the GOOSE tunnel
3. Configure the following parameter(s) as required:
Parameter Description
interface { interface } Synopsis:  A string
The interface to listen on for GOOSE frames.
multicast-mac { multicast-mac } Synopsis:  A string 17 characters long
The multicast MAC address to listen for.
This parameter is mandatory.
4. If necessary, configure one or more remote daemons for the tunnel. For more information, refer to
Section12.5.5.2, “Adding a Remote Daemon”.
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section12.5.4
Deleting a GOOSE Tunnel
To delete a GOOSE tunnel, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the GOOSE tunnel by typing:
no tunnel l2tunneld goose tunnel name
Where:
• name is the name of the GOOSE tunnel
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section12.5.5
Managing Remote Daemons for GOOSE Tunnels
In place of a local Ethernet interface for the tunnel egress, IP addresses for a remote daemon can be specified.
Several endpoints may be added with these fields using successive edits of the tunnel configuration.
CONTENTS
• Section12.5.5.1, “Viewing a List of Remote Daemons”
• Section12.5.5.2, “Adding a Remote Daemon”
• Section12.5.5.3, “Deleting a Remote Daemon”

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English