Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 16
Traffic Control and Classification
Adding an Egress Source Port 689
!
If no egress source ports have been configured, add egress source ports as needed. For more information, refer to
Section16.1.2.2, “Adding an Egress Source Port”.
Section16.1.2.2
Adding an Egress Source Port
To add an egress source port for port mirroring, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the egress source port by typing:
switch port-mirroring egress-src slot port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section16.1.2.3
Deleting an Egress Source Port
To delete an egress source port for port mirroring, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the address by typing:
no switch port-mirroring egress-src slot port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section16.1.3
Managing Ingress Source Ports
This section describes how to configure and manage egress source ports for port mirroring.
CONTENTS
• Section16.1.3.1, “Viewing a List of Ingress Source Ports”
• Section16.1.3.2, “Adding an Ingress Source Port”
• Section16.1.3.3, “Deleting an Ingress Source Port”

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English