Siemens RUGGEDCOM ROX II User Manual

Chapter 7
IP Address Assignment
RUGGEDCOM ROX II
CLI User Guide
266 Adding a Domain Name Server
!
!
If no domain name servers have been configured, add servers as needed. For more information, refer to
Section7.4.2.2, “Adding a Domain Name Server”.
Section7.4.2.2
Adding a Domain Name Server
To add a domain name server, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the domain name server by typing:
admin dns server address
Where:
• address is the IP address of the domain name server.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section7.4.2.3
Deleting a Domain Name Server
To delete a domain name server, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the domain name server by typing:
no admin dns server address
Where:
• address is the IP address of the domain name server.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English