Siemens RUGGEDCOM ROX II User Manual

Chapter 10
Serial Server
RUGGEDCOM ROX II
CLI User Guide
354 Deleting a Local Host Interface
1. Make sure the CLI is in Configuration mode.
2. Navigate to:
interface serial slot port protocols rawsocket setrawsocket local-host local-host interface
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• local-host is the local host
3. Configure the following parameter(s) as required:
Parameter Description
{ name } Synopsis:  A string
The receiving interface's name for the source multicast group IP address and the local
port number defined for the serial port.
4. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section10.8.3
Deleting a Local Host Interface
To delete a local host interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the local host by typing:
no interface serial slot port protocols rawsocket setrawsocket local-host local-host interface
interface name
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• local-host is the local host
• interface name is the name of the interface
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English