Siemens RUGGEDCOM ROX II User Manual

Chapter 13
Unicast and Multicast Routing
RUGGEDCOM ROX II
CLI User Guide
486
Viewing a List of Prepended Autonomous System Path
Filters
Section13.8.3.1
Viewing a List of Prepended Autonomous System Path Filters
To view a list of prepended autonomous system path filters configured for a BGP route map entry, type:
show running-config routing bgp filter route-map name entry number set as-path prepend
Where:
• name is the name of the route map
• number is the entry number
If filters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp filter route-map route entry 10 set as-path prepend
routing bgp
filter route-map route
entry 10
set as-path prepend 120
!
!
!
!
If no prepended autonomous system path filters have been configured, add filters as needed. For more
information, refer to Section13.8.3.3, “Adding a Prepended Autonomous System Path Filter”.
Section13.8.3.2
Viewing a List of Excluded Autonomous System Paths
To view a list of excluded autonomous system path filters configured for a BGP route map entry, type:
show running-config routing bgp filter route-map name entry number set as-path exclude
Where:
• name is the name of the route map
• number is the entry number
If filters have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp filter route-map route entry 10 set as-path exclude
routing bgp
filter route-map route
entry 10
set as-path exclude 110
!
!
!
!
If no excluded autonomous system path filters have been configured, add filters as needed. For more information,
refer to Section13.8.3.4, “Adding an Excluded Autonomous System Path filter”.
Section13.8.3.3
Adding a Prepended Autonomous System Path Filter
To add a prepended autonomous system path filter to a BGP route map entry, do the following:

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English