Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Chapter 15
Network Discovery and Management
Deleting an SNMP Security Model 681
2. Add the SNMP security model by typing:
admin snmp snmp-security-to-group model name { group | group }
Where:
• model is the security model. Options include range, v1, v2c and v3.
• name is the name of the associated user profile. Options include admin, guest and oper.
• group is the name of the associated SNMP group. If a group is not defined, the user is granted all access
rights by default.
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section15.2.8.3
Deleting an SNMP Security Model
To delete an SNMP security model, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the SNMP security model by typing:
no admin snmp snmp-security-to-group model name
Where:
• model is the security model
• name is the name of the associated user profile
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section15.2.9
Managing SNMP Group Access
This section describes how to manage access for SNMP groups.
CONTENTS
• Section15.2.9.1, “Viewing a List of SNMP Groups”
• Section15.2.9.2, “Adding an SNMP Group”
• Section15.2.9.3, “Deleting an SNMP Group”
Section15.2.9.1
Viewing a List of SNMP Groups
To view a list of SNMP groups configured on the device, type:
show running-config admin snmp snmp-access
If groups have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin snmp snmp-access | tab
SECURITY SECURITY READ VIEW WRITE VIEW NOTIFY

Siemens RUGGEDCOM ROX II Specifications

General

Brand	Siemens
Model	RUGGEDCOM ROX II
Category	Network Hardware
Language	English